APC AP9619, AP9618 quick start manual Choose Network from the Control Console menu

Quick Configuration

Control console After you log on at the control console, as described in either “Local access to the control console” on page 14 or “Remote access to the control console” on page 15:

1.Choose Network from the Control Console menu.

2.Choose TCP/IP from the Network menu.

3.If necessary, change the Boot Mode setting to Manual.

4.Set the System IP, Subnet Mask and Default Gateway address values.

5.Press CTRL-Cto exit to the Control Console menu.

6.Log out (option 4 in the Control Console menu) to have the changes take effect.

If you disconnected a cable during the procedure described in “Local access to the control console” on page 14, reconnect that

Note cable and restart the associated service.

16 Network Management Card