Aquacal 100 owner manual DEALER-SPECIFICTABLE of CONTENTS, Continued, Electrical Requirements

DEALER-SPECIFIC TABLE of CONTENTS

	(CONTINUED)
INSTALLATION INSTRUCTIONS (continued):
Electrical Requirements -------------------------------------------		44
General Requirements ------------------------------------------		44
Code-Specific Requirements -----------------------------------		44
Connecting External Controllers --------------------------------		44
Sizing the Electrical Service ------------------------------------		45
Ground Fault Protection (not recommended) ------------------		45
CONTROLS CONFIGURATION & ADJUSTMENTS ----------------------		46
Level-2 (dealer-service) Programming ----------------------------		46
1.	Entering Service Menu ---------------------------------------	46
2.	Time Delay ---------------------------------------------------	47
3.	Configuring for External Controllers -------------------------	47
4.	Water Sensor Calibration ------------------------------------	47
5.	Defrost Sensor Calibration -----------------------------------	48
6. Spa Dead Band Differential (and adjustment) --------------		49
7. Pool Dead Band Differential (and adjustment) -------------		49
8.	Changing Service Lock Code & “Back Door” Entry ----------	50
Level-2 Set Up & Calibration Codes -------------------------------		51
Factory Default Settings -------------------------------------------		51
Troubleshooting Using Displayed Codes --------------------------		52
Mode Jumper and Positioning -------------------------------------		53
Defrost Systems (described and explained) ----------------------		55
Water Flow Pressure Switch Adjustment--------------------------		56
CONTACTING THE FACTORY ------------------------------------------		58

33