Controls Configuration & Adjustments...
7.Pool Dead Band Differential...continued:
C.Once the desired dead band value has been selected, not pressing depressing any buttons for
8.Changing the Service Lock Code and “Back Door” Entry:
A.Changing the Code…
The factory default Service Lock Code is “50”. Service personnel are strongly advised to retain the factory default setting. However, should unauthorized access to
1)Follow the steps 1a. through 1d. above to enter the service menu. Once [dEL] is displayed, press the [POOL/SPA] key until the display shows [LOC] (LOCK CODE).
2)Press the [UP] arrow key to display the current service lock code value. With the current value displayed the [UP] arrow key will increase the value while the [DOWN] arrow key will decrease the value. When the desired value is displayed not pressing depressing any buttons for 15 seconds will allow the controller to save the selection and return to the normal operating mode. Pressing the {POOL/SPA] key will also save the selection and step to the next menu parameter. It is recommended, however, unless attempting to prevent tampering, that the factory setting of: “50” remain in use.
B.
1)Simultaneously depress and hold the [POOL/SPA] and [UP ARROW] keys until the display shows “888”. This operation will reset the controller to the factory default settings.
2)The factory reset will change the service lock code back to the factory setting “50”. In addition, all other settings (including external controller configuration) are returned to the factory defaults. See section in this manual entitled: “Factory Default Settings” for a complete list of factory default parameters.
50