Arcam T32 Aux input, Mains switch, DAB aerial input if fitted, Voltage select, AM aerial input

Aux input

	This socket can either be used in conjunction with the
Mains switch	RS232 port for the connection of an rDock, or as a		DAB aerial input (if fitted)
		standard line level input (see page 13).
This switch isolates the unit from			This input can be used with the ribbon aerial
mains power. The unit can be			provided, or connected to an external aerial (of the
placed in low power standby using			correct type) if required.
the standby button on the front		Remote in
panel or Pon the remote control
	This allows remote-control			Sirius input
	signals to be received by the T32
	if the remote sensor is covered or			This input is for a SiriusConnect™ Home Tuner
	otherwise ‘invisible’ to the remote			module. Sirius is a subscription radio service that is
	control (see page 4).			available throughout North America.

AUX

AUDIO OUT

IN

Power inlet

L

L

VOLTAGE SELECT

Connect the correct

O

I

R

R

110-120V 220-240V

1

2

DAB

FM 75½

mains cable here.

POWER INLET

OFF/ON

PROGRAM

RS232

IN

SIRIUS

GND

AM LOOP

~60Hz

~50Hz

REMOTE

Voltage select				Analogue audio outputs		AM aerial input
				Connect these to your amplifier’s tuner (or other line-		Connect the two AM Loop aerial
Ensure the voltage selected matches
				level) input using suitable high quality interconnect		leads – they are not polarised. In
the local power supply.
				cables. Ensure that the left and right audio outputs		addition, a 3m–5m external wire
	Program switch			from the T32 are connected to the corresponding left		can be fixed to AM Loop to improve
				and right inputs on your amplifier.		reception (see page 9).
For use by your Arcam dealer
				The second set of sockets can be used to connect to
during installation of software
		updates.		a second amplifier set up for multi-room use, or for
				direct recording.	FM aerial input
					This input can be		used with the ribbon aerial
			RS232 control		provided, or connected to an external aerial (of the
					correct type) if required. In Europe, a Belling-Lee
			This is used for	connecting an rDock or rLead for	connector is used; in North America, an F-type
			iPod® control (see page 6), or for controlling the T32		(screw) connector is used.
			from a remote computer.

Your Arcam dealer can provide a copy of the RS232 remote control protocol if required.

English

E-5