Manuals / Ariens / Lawn and Garden / Snow Blower

Ariens 24 LE (920014 s/n 100000 & up) quick start Quick Start Guide

Models: 24 LE (920014 s/n 100000 & up)

1 30

Download 30 pages 56.81 Kb

Page 1

Quick Start Guide

Compact 24 LE (920014 s/n 100000 & up)

•Step 1: Assemble Handlebar

•Step 2: Install Discharge Chute

•Step 3: Install Discharge Chute Crank

•Step 4: Install Remote Deflector Cable

•Step 5: Check Function of Dual Handle Interlock

•Step 6: Check Tire Pressure

•Step 7: Adjust Skid Shoes

•Step 8: Check Auger Gearcase Oil

•Step 9: Check Engine Crankcase Oil

•Step 10: Fill Engine Fuel Tank

•Step 11: Starting the Engine

•Step 12: Stopping the Engine

READ AND UNDERSTAND ALL INSTRUCTION, WARNING, AND DANGER LABELS. IMPORTANT: READ OPERATOR’S MANUAL AND ENGINE MANUAL THOROUGHLY AND FOLLOW THE IMPORTANT SAFE OPERATION PRACTICES BEFORE OPERATING.

Image 1

Ariens 24 LE (920014 s/n 100000 & up) quick start Quick Start Guide, Compact 24 LE 920014 s/n 100000 & up

Contents

Compact 24 LE 920014 s/n 100000 & up Quick Start GuideNot attached Step One Assemble HandlebarsNOTE This slide applies to UNATTACHED handlebars ONLY Step One Assemble Handlebars Unfold Lower HandlebarNOTE This slide applies to UNATTACHED handlebars ONLY Step One Assemble Handlebars Attach Upper Handlebar Assembly1. Hook Spring end of attachment control cable to the clutch arm Step One Assemble Handlebars Attach Control CablesNOTE Make sure cable remains in groove of pulley NOTE This slide applies to UNATTACHED handlebars ONLYNOTE This slide applies to UNATTACHED handlebars ONLY Step One Assemble Handlebars Unfold Upper HandlebarNOTE This slide applies to UNATTACHED handlebars ONLY Step One Connect Headlight Wire HarnessNOTE This slide applies to ATTACHED handlebars ONLY Step One Assemble Handlebar2. Remove mounting hardware from auger housing Step Two Install Discharge Chute1. Grease underside of discharge chute ring if not already greased Step Three Install Discharge Chute Crank Step Four Install Remote Deflector Cable Step Four Install Remote Deflector Cable Cont Step Five Check Function of Dual Handle Interlock Step Six Check Tire Pressure Step Seven Adjust Skid Shoes Check oil level in auger gearcase Step Eight Check Auger Gearcase Oilsee Check Auger Gearcase in Owners Manual IMPORTANT The engine is shipped with oil Step Nine Check Engine Crankcase Oilin crankcase. Refer to Engine Manual for detailed instructions Fill fuel tank. DO NOT OVERFILL! See Step Ten Fill Engine Fuel TankFILLING FUEL TANK in Owners ManualStep Eleven Starting the Engine Starting Engine / Step A Throttle Turn the fuel shut- off valve to the “ON” position Starting Engine / Step B Fuel ValveInsert the key and turn to the on/start position Starting Engine / Step C KeyStarting Engine / Step D Choke NOTE Choke is usually unnecessary when restarting a warm engineTurn the choke control knob to the choke position NOTE Priming is usually unnecessary when restarting a warm engine Starting Engine / Step E PrimeNOTE If the engine does not start after repeated attempts, go to Starting Engine / Step F Manual Startor call BRIGGSandSTRATTON.COMStarting Engine / Step F Electric Start Starting Engine / Step G Electric Start Starting Engine / Step H Warm up Step Twelve Stopping the Engine Additional Resources For issues concerning engine, please contact Briggs and StrattonRefer to Owners Manual and Engine Manual Contact Ariens Company E-mail info@ariens.com