Manuals / Ariens / Lawn and Garden / Snow Blower

Ariens 24 LE (920014 s/n 100000 & up) quick start Step One Assemble Handlebar

Models: 24 LE (920014 s/n 100000 & up)

1 30

Download 30 pages 56.81 Kb

Page 8

Step One:

Assemble Handlebar

1.Remove the lower and loosen the upper hardware on the handlebar assembly.

2.Loosen the hardware on the shift rod.

3.Put the speed selector lever in the sixth forward position.

4.Rotate the handlebar into operating position.

NOTE: Be careful not to damage cable spring hooks when rotating handlebar upward.

5.Install and tighten the hardware on the handlebar assembly and shift rod.

NOTE: This slide applies to ATTACHED handlebars ONLY

Image 8

Ariens 24 LE (920014 s/n 100000 & up) Step One Assemble Handlebar, NOTE This slide applies to ATTACHED handlebars ONLY

Contents

Quick Start Guide Compact 24 LE 920014 s/n 100000 & upStep One Assemble Handlebars Not attachedStep One Assemble Handlebars Unfold Lower Handlebar NOTE This slide applies to UNATTACHED handlebars ONLYStep One Assemble Handlebars Attach Upper Handlebar Assembly NOTE This slide applies to UNATTACHED handlebars ONLYStep One Assemble Handlebars Attach Control Cables 1. Hook Spring end of attachment control cable to the clutch armNOTE Make sure cable remains in groove of pulley NOTE This slide applies to UNATTACHED handlebars ONLYStep One Assemble Handlebars Unfold Upper Handlebar NOTE This slide applies to UNATTACHED handlebars ONLYStep One Connect Headlight Wire Harness NOTE This slide applies to UNATTACHED handlebars ONLYStep One Assemble Handlebar NOTE This slide applies to ATTACHED handlebars ONLY1. Grease underside of discharge chute ring if not already greased Step Two Install Discharge Chute2. Remove mounting hardware from auger housing Step Three Install Discharge Chute Crank Step Four Install Remote Deflector Cable Step Four Install Remote Deflector Cable Cont Step Five Check Function of Dual Handle Interlock Step Six Check Tire Pressure Step Seven Adjust Skid Shoes see Check Auger Gearcase in Owners Manual Step Eight Check Auger Gearcase OilCheck oil level in auger gearcase in crankcase. Refer to Engine Manual for detailed instructions Step Nine Check Engine Crankcase OilIMPORTANT The engine is shipped with oil Step Ten Fill Engine Fuel Tank Fill fuel tank. DO NOT OVERFILL! SeeFILLING FUEL TANK in Owners ManualStep Eleven Starting the Engine Starting Engine / Step A Throttle Starting Engine / Step B Fuel Valve Turn the fuel shut- off valve to the “ON” positionStarting Engine / Step C Key Insert the key and turn to the on/start positionTurn the choke control knob to the choke position NOTE Choke is usually unnecessary when restarting a warm engineStarting Engine / Step D Choke Starting Engine / Step E Prime NOTE Priming is usually unnecessary when restarting a warm engineStarting Engine / Step F Manual Start NOTE If the engine does not start after repeated attempts, go toor call BRIGGSandSTRATTON.COMStarting Engine / Step F Electric Start Starting Engine / Step G Electric Start Starting Engine / Step H Warm up Step Twelve Stopping the Engine For issues concerning engine, please contact Briggs and Stratton Additional ResourcesRefer to Owners Manual and Engine Manual Contact Ariens Company E-mail info@ariens.com