Manuals / Ariens / Lawn and Garden / Snow Blower

Ariens 24 LE (920014 s/n 100000 & up) quick start Step Four Install Remote Deflector Cable

Models: 24 LE (920014 s/n 100000 & up)

1 30

Download 30 pages 56.81 Kb

Page 11

Step Four: Install Remote

Deflector Cable

1.Pull rubber seal cap away from snap fitting.

2.Install snap fitting into cable bracket’s mounting hole located under the dash.

3.Position rubber seal cap over the top of snap fitting.

4.Move deflector control lever to forward most position.

5.Attach cable eye to pin on bottom of deflector control lever.

NOTE: Hold down chute deflector cap, if needed, for more cable slack.

Image 11

Ariens 24 LE (920014 s/n 100000 & up) quick start Step Four Install Remote Deflector Cable

Contents

Compact 24 LE 920014 s/n 100000 & up Quick Start GuideNot attached Step One Assemble HandlebarsNOTE This slide applies to UNATTACHED handlebars ONLY Step One Assemble Handlebars Unfold Lower HandlebarNOTE This slide applies to UNATTACHED handlebars ONLY Step One Assemble Handlebars Attach Upper Handlebar AssemblyNOTE This slide applies to UNATTACHED handlebars ONLY Step One Assemble Handlebars Attach Control Cables1. Hook Spring end of attachment control cable to the clutch arm NOTE Make sure cable remains in groove of pulleyNOTE This slide applies to UNATTACHED handlebars ONLY Step One Assemble Handlebars Unfold Upper HandlebarNOTE This slide applies to UNATTACHED handlebars ONLY Step One Connect Headlight Wire HarnessNOTE This slide applies to ATTACHED handlebars ONLY Step One Assemble Handlebar1. Grease underside of discharge chute ring if not already greased Step Two Install Discharge Chute2. Remove mounting hardware from auger housing Step Three Install Discharge Chute Crank Step Four Install Remote Deflector Cable Step Four Install Remote Deflector Cable Cont Step Five Check Function of Dual Handle Interlock Step Six Check Tire Pressure Step Seven Adjust Skid Shoes see Check Auger Gearcase in Owners Manual Step Eight Check Auger Gearcase OilCheck oil level in auger gearcase in crankcase. Refer to Engine Manual for detailed instructions Step Nine Check Engine Crankcase OilIMPORTANT The engine is shipped with oil Owners Manual Step Ten Fill Engine Fuel TankFill fuel tank. DO NOT OVERFILL! See FILLING FUEL TANK inStep Eleven Starting the Engine Starting Engine / Step A Throttle Turn the fuel shut- off valve to the “ON” position Starting Engine / Step B Fuel ValveInsert the key and turn to the on/start position Starting Engine / Step C KeyTurn the choke control knob to the choke position NOTE Choke is usually unnecessary when restarting a warm engineStarting Engine / Step D Choke NOTE Priming is usually unnecessary when restarting a warm engine Starting Engine / Step E PrimeBRIGGSandSTRATTON.COM Starting Engine / Step F Manual StartNOTE If the engine does not start after repeated attempts, go to or callStarting Engine / Step F Electric Start Starting Engine / Step G Electric Start Starting Engine / Step H Warm up Step Twelve Stopping the Engine E-mail info@ariens.com For issues concerning engine, please contact Briggs and StrattonAdditional Resources Refer to Owners Manual and Engine Manual Contact Ariens Company