Manuals / Ariens / Lawn and Garden / Snow Blower

Ariens 24 LE (920014 s/n 100000 & up) quick start Step One Connect Headlight Wire Harness

Models: 24 LE (920014 s/n 100000 & up)

1 30

Download 30 pages 56.81 Kb

Page 7

Step One:

(Connect Headlight Wire Harness)

NOTE: The headlight wire harness comes attached to the upper handlebar assembly.

1.Route the wire harness along the interior of the right side handlebar.

2.Connect to the engine electrical plug.

3.Press cable anchor into mounting hole in the frame near the engine electrical plug.

4.Secure the wire harness to the handlebars using the cable ties attached to the wire harness.

5.Gather excess wire harness length and fasten together with cable tie included in literature pack.

NOTE: This slide applies to

UNATTACHED handlebars ONLY

Image 7

Ariens 24 LE (920014 s/n 100000 & up) quick start Step One Connect Headlight Wire Harness

Contents

Compact 24 LE 920014 s/n 100000 & up Quick Start GuideNot attached Step One Assemble HandlebarsNOTE This slide applies to UNATTACHED handlebars ONLY Step One Assemble Handlebars Unfold Lower HandlebarNOTE This slide applies to UNATTACHED handlebars ONLY Step One Assemble Handlebars Attach Upper Handlebar AssemblyNOTE This slide applies to UNATTACHED handlebars ONLY Step One Assemble Handlebars Attach Control Cables1. Hook Spring end of attachment control cable to the clutch arm NOTE Make sure cable remains in groove of pulleyNOTE This slide applies to UNATTACHED handlebars ONLY Step One Assemble Handlebars Unfold Upper HandlebarNOTE This slide applies to UNATTACHED handlebars ONLY Step One Connect Headlight Wire HarnessNOTE This slide applies to ATTACHED handlebars ONLY Step One Assemble Handlebar2. Remove mounting hardware from auger housing Step Two Install Discharge Chute1. Grease underside of discharge chute ring if not already greased Step Three Install Discharge Chute Crank Step Four Install Remote Deflector Cable Step Four Install Remote Deflector Cable Cont Step Five Check Function of Dual Handle Interlock Step Six Check Tire Pressure Step Seven Adjust Skid Shoes Check oil level in auger gearcase Step Eight Check Auger Gearcase Oilsee Check Auger Gearcase in Owners Manual IMPORTANT The engine is shipped with oil Step Nine Check Engine Crankcase Oilin crankcase. Refer to Engine Manual for detailed instructions Owners Manual Step Ten Fill Engine Fuel TankFill fuel tank. DO NOT OVERFILL! See FILLING FUEL TANK inStep Eleven Starting the Engine Starting Engine / Step A Throttle Turn the fuel shut- off valve to the “ON” position Starting Engine / Step B Fuel ValveInsert the key and turn to the on/start position Starting Engine / Step C KeyStarting Engine / Step D Choke NOTE Choke is usually unnecessary when restarting a warm engineTurn the choke control knob to the choke position NOTE Priming is usually unnecessary when restarting a warm engine Starting Engine / Step E PrimeBRIGGSandSTRATTON.COM Starting Engine / Step F Manual StartNOTE If the engine does not start after repeated attempts, go to or callStarting Engine / Step F Electric Start Starting Engine / Step G Electric Start Starting Engine / Step H Warm up Step Twelve Stopping the Engine E-mail info@ariens.com For issues concerning engine, please contact Briggs and StrattonAdditional Resources Refer to Owners Manual and Engine Manual Contact Ariens Company