Manuals / Ariens / Lawn and Garden / Snow Blower

Ariens 24 LE (920014 s/n 100000 & up) Step One Assemble Handlebars Unfold Lower Handlebar

Models: 24 LE (920014 s/n 100000 & up)

1 30

Download 30 pages 56.81 Kb

Page 3

Step One: Assemble Handlebars

(Unfold Lower Handlebar)

1.Remove wheel pins from each side of the unit and slide wheels away from frame. Do not remove wheels completely.

IMPORTANT: Be sure to block wheels or secure unit so it does not move during assembly.

2.Rotate lower handlebar out from unit so lower handlebar mounting holes align with mounting holes on the unit frame.

3.Secure lower handlebar to unit using two 3/8 in x 3/4 in. hex head serrated flange grade 5 bolts.

4.Tighten all four bolts to 25-42 lbf-ft (33,9-56,9 N∙m)

5.Slide both wheels back into place and reinstall wheel pins.

NOTE: This slide applies to

UNATTACHED handlebars ONLY

Image 3

Ariens 24 LE (920014 s/n 100000 & up) quick start Step One Assemble Handlebars Unfold Lower Handlebar

Contents

Compact 24 LE 920014 s/n 100000 & up Quick Start GuideNot attached Step One Assemble HandlebarsNOTE This slide applies to UNATTACHED handlebars ONLY Step One Assemble Handlebars Unfold Lower HandlebarNOTE This slide applies to UNATTACHED handlebars ONLY Step One Assemble Handlebars Attach Upper Handlebar AssemblyNOTE This slide applies to UNATTACHED handlebars ONLY Step One Assemble Handlebars Attach Control Cables1. Hook Spring end of attachment control cable to the clutch arm NOTE Make sure cable remains in groove of pulleyNOTE This slide applies to UNATTACHED handlebars ONLY Step One Assemble Handlebars Unfold Upper HandlebarNOTE This slide applies to UNATTACHED handlebars ONLY Step One Connect Headlight Wire HarnessNOTE This slide applies to ATTACHED handlebars ONLY Step One Assemble HandlebarStep Two Install Discharge Chute 2. Remove mounting hardware from auger housing1. Grease underside of discharge chute ring if not already greased Step Three Install Discharge Chute Crank Step Four Install Remote Deflector Cable Step Four Install Remote Deflector Cable Cont Step Five Check Function of Dual Handle Interlock Step Six Check Tire Pressure Step Seven Adjust Skid Shoes Step Eight Check Auger Gearcase Oil Check oil level in auger gearcasesee Check Auger Gearcase in Owners Manual Step Nine Check Engine Crankcase Oil IMPORTANT The engine is shipped with oilin crankcase. Refer to Engine Manual for detailed instructions Owners Manual Step Ten Fill Engine Fuel TankFill fuel tank. DO NOT OVERFILL! See FILLING FUEL TANK inStep Eleven Starting the Engine Starting Engine / Step A Throttle Turn the fuel shut- off valve to the “ON” position Starting Engine / Step B Fuel ValveInsert the key and turn to the on/start position Starting Engine / Step C KeyNOTE Choke is usually unnecessary when restarting a warm engine Starting Engine / Step D ChokeTurn the choke control knob to the choke position NOTE Priming is usually unnecessary when restarting a warm engine Starting Engine / Step E PrimeBRIGGSandSTRATTON.COM Starting Engine / Step F Manual StartNOTE If the engine does not start after repeated attempts, go to or callStarting Engine / Step F Electric Start Starting Engine / Step G Electric Start Starting Engine / Step H Warm up Step Twelve Stopping the Engine E-mail info@ariens.com For issues concerning engine, please contact Briggs and StrattonAdditional Resources Refer to Owners Manual and Engine Manual Contact Ariens Company