Manuals
/
Ariens
/
Lawn and Garden
/
Snow Blower
Ariens
24 LE (920014 s/n 100000 & up) quick start Starting Engine / Step E Prime
Models:
24 LE (920014 s/n 100000 & up)
1
24
30
30
Download
30 pages
56.81 Kb
21
22
23
24
25
26
27
28
<
>
Install
Step One Connect Headlight Wire Harness
For issues concerning engine, please contact Briggs and Stratton
Step One Assemble Handlebars Attach Upper Handlebar Assembly
Step Seven Adjust Skid Shoes
How to
Page 24
Image 24
Starting Engine / Step E:
Prime
Push the primer two times. Be sure to cover the vent hole on the primer bulb.
NOTE:
Priming is usually unnecessary when restarting a warm engine.
Page 23
Page 25
Page 24
Image 24
Page 23
Page 25
Contents
Quick Start Guide
Compact 24 LE 920014 s/n 100000 & up
Step One Assemble Handlebars
Not attached
Step One Assemble Handlebars Unfold Lower Handlebar
NOTE This slide applies to UNATTACHED handlebars ONLY
Step One Assemble Handlebars Attach Upper Handlebar Assembly
NOTE This slide applies to UNATTACHED handlebars ONLY
Step One Assemble Handlebars Attach Control Cables
1. Hook Spring end of attachment control cable to the clutch arm
NOTE Make sure cable remains in groove of pulley
NOTE This slide applies to UNATTACHED handlebars ONLY
Step One Assemble Handlebars Unfold Upper Handlebar
NOTE This slide applies to UNATTACHED handlebars ONLY
Step One Connect Headlight Wire Harness
NOTE This slide applies to UNATTACHED handlebars ONLY
Step One Assemble Handlebar
NOTE This slide applies to ATTACHED handlebars ONLY
Step Two Install Discharge Chute
2. Remove mounting hardware from auger housing
1. Grease underside of discharge chute ring if not already greased
Step Three Install Discharge Chute Crank
Step Four Install Remote Deflector Cable
Step Four Install Remote Deflector Cable Cont
Step Five Check Function of Dual Handle Interlock
Step Six Check Tire Pressure
Step Seven Adjust Skid Shoes
Step Eight Check Auger Gearcase Oil
Check oil level in auger gearcase
see Check Auger Gearcase in Owners Manual
Step Nine Check Engine Crankcase Oil
IMPORTANT The engine is shipped with oil
in crankcase. Refer to Engine Manual for detailed instructions
Step Ten Fill Engine Fuel Tank
Fill fuel tank. DO NOT OVERFILL! See
FILLING FUEL TANK in
Owners Manual
Step Eleven Starting the Engine
Starting Engine / Step A Throttle
Starting Engine / Step B Fuel Valve
Turn the fuel shut- off valve to the “ON” position
Starting Engine / Step C Key
Insert the key and turn to the on/start position
NOTE Choke is usually unnecessary when restarting a warm engine
Starting Engine / Step D Choke
Turn the choke control knob to the choke position
Starting Engine / Step E Prime
NOTE Priming is usually unnecessary when restarting a warm engine
Starting Engine / Step F Manual Start
NOTE If the engine does not start after repeated attempts, go to
or call
BRIGGSandSTRATTON.COM
Starting Engine / Step F Electric Start
Starting Engine / Step G Electric Start
Starting Engine / Step H Warm up
Step Twelve Stopping the Engine
For issues concerning engine, please contact Briggs and Stratton
Additional Resources
Refer to Owners Manual and Engine Manual Contact Ariens Company
E-mail info@ariens.com