Manuals / Ariens / Lawn and Garden / Snow Blower

Ariens 24 LE (920014 s/n 100000 & up) quick start Step Four Install Remote Deflector Cable Cont

Models: 24 LE (920014 s/n 100000 & up)

1 30

Download 30 pages 56.81 Kb

Page 12

Step Four: Install Remote

Deflector Cable Cont.

6.Secure cable eye to control lever with sleeve bushing and hairpin.

7.Using the wire hook attached to the deflector cable, hook cable to discharge chute crank.

8.Install cable into clip on top of discharge chute pedestal.

9.Make sure deflector cable loops above gear cover between cable clip and cable support bracket.

10.Test controls to be sure deflector works properly.

NOTE: If deflector does not follow full range of travel See Remote Discharge Deflector Control Adjustment in Owners Manual.

Image 12

Ariens 24 LE (920014 s/n 100000 & up) quick start Step Four Install Remote Deflector Cable Cont

Contents

Quick Start Guide Compact 24 LE 920014 s/n 100000 & upStep One Assemble Handlebars Not attachedStep One Assemble Handlebars Unfold Lower Handlebar NOTE This slide applies to UNATTACHED handlebars ONLYStep One Assemble Handlebars Attach Upper Handlebar Assembly NOTE This slide applies to UNATTACHED handlebars ONLYStep One Assemble Handlebars Attach Control Cables 1. Hook Spring end of attachment control cable to the clutch armNOTE Make sure cable remains in groove of pulley NOTE This slide applies to UNATTACHED handlebars ONLYStep One Assemble Handlebars Unfold Upper Handlebar NOTE This slide applies to UNATTACHED handlebars ONLYStep One Connect Headlight Wire Harness NOTE This slide applies to UNATTACHED handlebars ONLYStep One Assemble Handlebar NOTE This slide applies to ATTACHED handlebars ONLYStep Two Install Discharge Chute 2. Remove mounting hardware from auger housing1. Grease underside of discharge chute ring if not already greased Step Three Install Discharge Chute Crank Step Four Install Remote Deflector Cable Step Four Install Remote Deflector Cable Cont Step Five Check Function of Dual Handle Interlock Step Six Check Tire Pressure Step Seven Adjust Skid Shoes Step Eight Check Auger Gearcase Oil Check oil level in auger gearcasesee Check Auger Gearcase in Owners Manual Step Nine Check Engine Crankcase Oil IMPORTANT The engine is shipped with oilin crankcase. Refer to Engine Manual for detailed instructions Step Ten Fill Engine Fuel Tank Fill fuel tank. DO NOT OVERFILL! SeeFILLING FUEL TANK in Owners ManualStep Eleven Starting the Engine Starting Engine / Step A Throttle Starting Engine / Step B Fuel Valve Turn the fuel shut- off valve to the “ON” positionStarting Engine / Step C Key Insert the key and turn to the on/start positionNOTE Choke is usually unnecessary when restarting a warm engine Starting Engine / Step D ChokeTurn the choke control knob to the choke position Starting Engine / Step E Prime NOTE Priming is usually unnecessary when restarting a warm engineStarting Engine / Step F Manual Start NOTE If the engine does not start after repeated attempts, go toor call BRIGGSandSTRATTON.COMStarting Engine / Step F Electric Start Starting Engine / Step G Electric Start Starting Engine / Step H Warm up Step Twelve Stopping the Engine For issues concerning engine, please contact Briggs and Stratton Additional ResourcesRefer to Owners Manual and Engine Manual Contact Ariens Company E-mail info@ariens.com