1
|
| |
1. | Chute Crank |
|
2. | Support Bracket |
|
3. | Pinion Gear |
|
4. | Spring Clip Pin |
|
| Figure 11 | OS8060 |
(Figures 12 and 13)
1.Pull rubber seal cap away from snap fitting (Figure 12).
.
2
|
|
| 4 |
1. | Mounting Hole | 4. | Hairpin |
2. | Snap Fitting | 5. | Bushing |
3. | Rubber Seal | 6. | Cable Eye |
| Cap |
|
|
Figure 12
2.Install snap fitting into cable bracket’s mounting hole located under the control panel.
3.Position rubber seal cap over the top of snap fitting.
4.Move deflector control lever to rear most position.
5.Attach cable eye to pin on bottom of deflector control lever.
NOTICE: Hold down chute deflector cap, if needed, for more cable slack.
6.Secure cable eye to control lever with bushing and hairpin.
7.Using the wire hook attached to the deflector cable, hook cable to discharge chute crank.
EN - 12