8.Install cable into clip on top of discharge chute pedestal (Figure 13).

.

4

2

 

3

1

6

5

7

1.Remote Deflector Cable

2.Remote Deflector Control

3.Cable Clip

4.Wire Cable Hook

5.Cable Mounting Bracket

6.Cable Support Bracket

7.Gear Cover

Figure 13

9.Make sure deflector cable loops above gear cover between cable clip and cable support bracket (Figure 13).

10.Test controls to be sure deflector works properly.

NOTICE: If deflector does not follow full range of travel see Remote Discharge Deflector Control Adjustment on page 29.

Check Function of Dual Handle Interlock

Without the engine running, press down (engage) both clutch levers. Release attachment clutch lever. Attachment clutch should remain engaged until traction drive clutch lever is released, then both clutches must disengage. If they do not, contact your Dealer for repairs.

CAUTION: Avoid injury! Explosive separation of tire and rim parts is possible when they are serviced incorrectly:

•Do not attempt to mount a tire without the proper equipment and experience to perform the job.

•Do not inflate the tires above the recommended pressure.

•Do not weld or heat a wheel and tire assembly. Heat can cause an increase in air pressure resulting in an explosion. Welding can structurally weaken or deform the wheel.

•Do not stand in front or over the tire assembly when inflating. Use a clip-on chuck and extension hose long enough to allow you to stand to one side.

Check Track Tension (920020)

Check tracking of unit and tension the tracks

as required (see Traction Tension Adjustment

on page 37).

Check Auger Gearcase Oil

Check oil level in auger gearcase (see Check

Auger Gearcase on page 24).

Check Engine Crankcase Oil

IMPORTANT: The engine may be shipped with oil in crankcase. Refer to Engine Manual for detailed instructions.

Fill Engine Fuel Tank

Fill fuel tank. DO NOT OVERFILL! See

FILLING FUEL TANK on page 20.

Check Function Of All Controls

Ensure unit runs and performs properly. Refer to OPERATION on page 17.

Check Tire Pressure (920013, 014, 021)

Check tire pressure and adjust to the pressure listed on tire sidewall.

Run-in Attachment Belt

1.Start unit in a well-ventilated area according to Starting and Shut Off on page 21.

2.Engage attachment clutch lever and run attachment for about 15 minutes.

3.Stop unit, wait for all moving parts to stop, and remove spark plug wire.

4.Adjust clutch idler according to Attachment Clutch/Brake Adjustment on page 30.

5.Adjust belt finger, if necessary. See Check Belt Finger Clearance on page 32.

EN - 13