MAINTENANCE SCHEDULE
The chart below shows the recommended maintenance schedule that should be performed on a regular basis. More frequent service may be required.
MAINTENANCE SCHEDULE
Service | Each Use | Every hrs.5 | Every hrs.25 | Yearly |
Performed |
|
|
|
|
|
|
|
|
|
Check Dual | • |
|
|
|
Handle |
|
|
|
|
Interlock |
|
|
|
|
|
|
|
|
|
Check | • |
|
|
|
Fasteners |
|
|
|
|
|
|
|
|
|
Check Clutch | • |
|
|
|
Operation |
|
|
|
|
|
|
|
|
|
Check Clutch |
| * | • |
|
Cable |
|
|
|
|
Adjustments |
|
|
|
|
|
|
|
|
|
Clean Engine | • |
|
|
|
|
|
|
|
|
Check Engine |
| • |
|
|
Oil |
|
|
|
|
|
|
|
|
|
Change |
|
|
|
|
Engine Oil** |
|
|
|
|
|
|
|
|
|
Check Tire |
|
| • |
|
Pressure |
|
|
|
|
|
|
|
|
|
Check Track |
|
|
| • |
Tension |
|
|
|
|
|
|
|
|
|
Check Auger |
|
| • | • |
Gearcase |
|
|
|
|
|
|
|
|
|
General |
|
| • | • |
Lubrication |
|
|
|
|
|
|
|
|
|
*After first five hours of operation.
**Refer to Engine Manual for detailed instructions.
CHECK DUAL HANDLE
INTERLOCK
Without the engine running, press down (engage) both clutch levers. Release attachment clutch lever. Attachment clutch should remain engaged until traction drive clutch lever is released, then both clutches must disengage.
CHECK FASTENERS
Make sure all hardware is tightened properly.
CHECK CLUTCH OPERATION
Auger / impeller must stop within 5 seconds when attachment clutch lever is released.
Wheels must stop quickly when traction drive clutch lever is released.
If clutches do not engage or disengage properly, adjust or repair before operation. See Attachment Clutch/Brake Adjustment on page 30 and Traction Drive Clutch Adjustment on page 33.
CHECK CLUTCH CABLE
ADJUSTMENT
Make sure the attachment clutch and traction drive clutch are adjusted as specified in Attachment Clutch/Brake Adjustment on page 30 and Traction Drive Clutch Adjustment on page 33.
CLEAN ENGINE
Refer to Engine Manual for detailed instructions.
CHECK ENGINE OIL
The engine crankcase oil should be checked every 5 hours of operation. Oil level MUST be maintained in safe operating range on dipstick at all times or engine damage will result (See Engine Manual).
Park unit on a level surface. Refer to Engine Manual for detailed instructions.
CHANGE ENGINE OIL
Refer to Engine Manual for detailed instructions.
NOTICE: Run engine just prior to changing oil. Warm oil will flow more freely and carry away more contaminants.
CHECK TIRE PRESSURE
(920013, 014, 021)
Keep tires at pressure listed on the tire
sidewall. See Check Tire Pressure on
CHECK AUGER GEARCASE
(Figure 21)
IMPORTANT: Proper oil level must be maintained.
Gear cases are filled to the correct level at the factory. Unless there is evidence of leakage, no additional lubricant should be required. Check oil level each season or every 25 hours of operation.
IMPORTANT: Be sure unit is resting on a level surface before checking lubricant levels.
EN - 24