Ariston KT 8104 QO manual Installation, screws should be accessible at all times for this purpose

Installation

These instructions are intended for the qualified technician installing the appliance in order to insure that the installation, adjustments and maintenance procedures are performed correctly and comply with the regulations currently in effect.

Important: the cooktop must be disconnected from the power supply before making any adjustments or performing any maintenance, etc.

Installing built-in cooktops

The cooktops have a type X protection rating against overheating in compliance with regulation CEI 335-2-6. Therefore, the cooktops cannot be installed alongside of cabinets which are higher than the surface of the cooktop itself. The following precautionary measures should be observed in order to ensure proper installation:

a)Hoods must be installed in compliance with the required specifications contained in the instruction manual for the hood itself.

b)The built-in ceramic glass top can be installed on any counter top as long as it is 600 mm or more in width and resistant to temperatures of up to 100°C. The dimensions and the position of the hole are shown in fig..

The four securing springs are held in place by 4 Torx screws.

To remove the hob unit from its housing, undo the 2 Torx screws at the front, then the 2 Torx screws at the rear.

The 4 screws should be accessible at all times for this purpose.

REAR SPRING ASSEMBLY

FRONT OF THE HOB UNIT

REAR LEFT MOUNTING

REAR RIGHT MOUNTING

WORK
SURFACE	30	40

HOB UNIT FACE DOWN

	FRONT LEFT MOUNTING
FRONT RIGHT MOUNTING
SEAL MOUNTING
FRONT / REAR	RIGHT / LEFT

48

560	+/-
	1

595
	10
	510
	1
	-
490	+/

Leave this much space between the bottom and the cabinetry

MOUSSE 5x8 mm

c)If a wooden panel is installed beneath the cooktop for insulation purposes, it must be positioned at least 20 mm from the bottom part of the cooktop itself.

Note: If the cooktop is installed above a built-in oven, it is preferable that the oven be installed in such a way that it is set on two strips of wood; if, on the other hand, the oven is installed on a continuous base, there must be an opening in the back of at least 45 x 560 mm.

X (CEI 335-2-6)

The aforementioned measurements must absolutely be observed in so far as improper installation can cau- se the surrounding surface areas to overheat. It is recommended that the cooktop be installed at a distance of at least 40 mm from the back wall or other vertical surfaces to ensure that the air circulates properly over the cooking area and to avoid overheating the surrounding surfaces. A seal or gasket is provided with the cooktop; make sure that it adheres properly to the bottom part of the frame of the cooktop. It is indispensable that the seal fits properly around the entire cooktop frame and especially along the corners in order to create a seal between the counter top and the cooktop itself so as to prevent spills or splashes from leaking into the cabinet below.

Very important

It is essential to instali the hob on a totally flat surtace. Any damage caused by incorrect fitting may alter the characteristics or impair performance.

Insert the cooktop into the hole, pressing firmly around the frame to make it adhere to the counter top.

Make certain that the seal around the outside edge of the hob is correctly installed in order to avoid any leakage into the cabinetry below.

.	45	mm.
mm
560

The built-in oven must be equipped with a forced air cooling system.

9