| Step 14 | ● Parts Needed For ● | ● 8468 Right Roof Panel (1) |
|
| ● 8469 Left Roof Panel (2) |
| ||
| RoofAssembly | ● 7483 Roof Panel (2) |
| |
| ● 6529 Roof Panel (2) |
| ||
| A27 |
|
| |
|
|
|
| |
|
|
|
|
|
|
|
|
|
|
1 Install a left roof panel at the left
STEP
STEP
rear and right front corner of the roof. Install a right roof panel at the left
8469 Left Roof Panel
7483 Roof Panel
1
2
front corner of the roof.
2 Cut 4 short 2" (5cm) strips off the roll of weather stripping tape, and put them aside. Cover the joint at the peak with weather stripping tape. Unroll the tape and press it down over the opening at the ridge as you install each roof panel. Do not cut the tape at this time.
3 Install 2 narrow and 2 wide roof
panels in the sequence and posi- tions shown on previous page. Do not fasten the lower end of the panels to the side wall angles at this time. Continue weather stripping the ridge opening.
6529 Roof Panel
8468 Right Roof Panel
Weather Stripping 7483 Roof Panel Tape Roll
6529 Roof Panel
STEP
3
NOTE
Narrow roof panel crimped rib is
overlapped by wide rib of
adjacent panel where possible.
Fasten At
Overlap with
Bolt
Screws To
Roof Beam
NOTE
If roof beam holes do not line up with the roof panel holes, shift the building from left to right.
If this does not help, your building
may not be level. Shim the corners until holes line up.
Screws To
Roof Beam
Fasten At
Overlap with
Bolt
Do not fasten
at this time
27