ASRock E3C224 manual Speaker Header

A. Front panel SMBus connecting pin (6-pin FPSMB)

This header allows you to connect SMBus (System Management Bus) equipment. It can be used for communication between peripheral equipment in the system, which has slower transmission rates, and power management equipment.

B. Internet status indicator (2-pin LAN1_LED, LAN2_LED) These two 2-pin headers allow you to use the Gigabit internet indicator cable to connect to the LAN status indicator. When this indicator flickers, it means that the internet is properly connected.

C. Chassis intrusion pin (2-pin CHASSIS)

This header is provided for host computer chassis with chassis intrusion detection designs. In addition, it must also work with external detection equipment, such as a chassis intrusion detection sensor or a microswitch. When this function is activated, if any chassis component movement occurs, the sensor will immediately detect it and send a signal to this header, and the system will then record this chassis intrusion event. The default setting is set to the CASEOPEN and GND pin; this function is off.

D. Locator LED (6-pin LOCATOR)

This header is for the locator switch and LED on the front panel.

Speaker Header

(4-pin SPEAKER1) (see p.18, 21, 24)

DUMMY SPEAKER

1

+5V DUMMY

Please connect the speaker to this header.

Front and Rear Fan Connectors

(4-pin FRNT_FAN1) (4-pin FRNT_FAN2) (4-pin FRNT_FAN3) (see p.18, 21, 24)

(4-pin REAR_FAN1) (see p.18, 21, 24)

FAN_SPEED_CONTROL

FAN_SPEED

+12V GND

1GND

2+12V

3FAN_SPEED

4 FAN_SPEED_CONTROL

Please connect the fan cables to the fan connectors and match the black wire to the ground pin. All fans sup- ports Fan Control.

46