Rev. A.3, 5/00
SECTION 3. ELECTRICAL INSTALLATION | Page 13 |
SECTION 3.1 GENERAL ELECTRICAL CHARACTERISTICS | Page 13 |
This section explains technically the Magnalock's electrical characteristics as a load and is for reference.
SECTION 3.2 | STANDARD LOCK | Page 13 |
This section explains powering and switching the Magnalock. |
| |
SECTION 3.3 | AVOIDING POOR RELEASE | Page 13 |
This section warns against wiring mistakes specific only to the model 32 series.
SECTION 3.4 WIRE GAUGE | Page 14 |
This reference section explains how to select wire size for applications where the lock is distant from the power supply.
SECTION 3.5 | SENSTAT MAGNALOCKS: | Page 14 |
Read this section if you have a Senstat Magnalock. |
| |
SECTION 3.6 | DOUBLE DOOR PROCEDURE FOR STATUS | Page 15 |
This section applies if you have Senstat locks on a double door and want them to report as a single lock.
SECTION 3.7 DOUBLE DOOR CONTROL | Page 15 |
This section applies whenever you have two locks controlled by a single switch.
SECTION 3.8 EMERGENCY RELEASE | Page 16 |
This section should be understood by all installers.
APPENDIX A | Page i |
Refer to this section before calling the factory on any operating problem. |
|
APPENDIX B CALCULATING WIRE GAUGE | Page ii |
This detailed reference section explains how to select wire gauge in complicated
APPENDIX C CONSIDERATIONS FOR MAXIMUM PHYSICAL SECURITY | Page iii |
This reference section explains the technical aspects of lock holding force and resistance to attack. It contains numerous installation techniques which act to insure high lock security. It must be read for high security applications and also has excellent educational value.
