Manuals / Brands / Computer Equipment / Server / Asus / Computer Equipment / Server

Asus AP3000 •1-4.Safeguards, Operation Safety, Tools Required

1 42

Download 42 pages, 912.57 Kb

Safeguards	Introduction .I

I.Introduction

•1-4. Safeguards

Observe the following safety instructions any time you are connecting or disconnecting any devices.

Operation Safety

IMPORTANT

• Any operation on this server must be conducted by certified or experienced engineers.

•Before operating your server, carefully read all the manuals included with the server package.

•Before using the server, make sure all cables are cor- rectly connected and the power cables are not dam- aged. If any damage is detected, contact your dealer as soon as possible.

•To avoid short circuits, keep paper clips, screws, and staples away from connectors, slots, sockets and cir- cuitry.

•Before opening the chassis panels, make sure all power cables are unplugged.

•Avoid dust, humidity, and temperature extremes. Place the server on a stable surface.

•If the power supply is broken, do not try to fix it by yourself. Contact an authorized dealer.

•It is recommanded that you wear gloves when assem- bling or dissembling the server to protect from cuts and scrapes.

•When the server is powered on, heat sinks and the sur- faces of certain IC devices may be hot. Do not touch them. Check whether the fans are functioning properly.

Tools Required

A Phillips (cross) screwdriver and a standard (flat) screwdriver are needed to install or remove the components in this server.

10	AP 3000 Hardware Reference Guide

Contents

Page Page ASUSTeK COMPUTER INC. (Asia-Pacific) ASUS COMPUTER INTERNATIONAL (America) ASUS COMPUTER GmbH (Europe) I. Introduction II. Components III. Basic Operation IV. Hardware Setup Page Federal Communications Commission Statement Canadian Department of Communications Statement •1-1.How this Manual is Organized Symbols •1-2.Component Checklist Standard components Optional components •1-3.Features •1-4.Safeguards Operation Safety Tools Required •1-5.Electrical Safety Page •2-1.Server Front Side •2-2.Server Back Side •2-3.Server Left Side •3-1.Starting the Server • 3-2.LEDs • 3-3.BIOS Setup • 4-1.Opening the Chassis Panel Screws Removing the Right Panel Opening the Left Panel Chassis Circulation System • 4-2.Rear Cooling Fan Control Board Rear Cooling Fan Control Board Settings • 4-3.Motherboard Spacers Install the Baseboard Screws Device Cables Cable Connections • 4-4.Central Processing Unit (CPU) Install Retention Mechanisms Mechanism Brace Bars Install Cartridge Lifters Mechanism Cap Frame • 4-5.Chassis Intrusion Switch Intrusion Connector • 4-6.Expansion Cards • 4-7.Fixed Storage Devices Floppy Drive and CD-ROM Fixed Storage Device Tray Fixed Device Bay Cover Clips Storage Device • 4-8. Five-Tray Hot-SwapBay • 4-9. Three-Tray Hot-SwapBay Hot-SwapTray Hot-SwapBay • 4-10.Front Cooling Fans Front Cooling Fan Control Board Hard Disk Drive Message Board • 4-11.SCSI Backplane • 4-12.SCSI ID Setting SCSI ID Dip Switches SCSI ID Dip Switches (Cont’) • 4-13.Expansion Card Guide Securing Expansion Card Guide • 4-14.SCSI Termination • 4-15.Power Supply Power Supply Mounting Power Supply Information • 4-16.Power Supply Requirement Power Supply Requirement Calculation Table Page i.SCSI Cable Limits ii. Glossary Peripherals POST (Power On Self Test) PS/2 Port RAID (Redundant Array of Inexpensive Disks) RAM (Random Access Memory) (This page was intentionally left blank.)