Manuals / Brands / Computer Equipment / Server / Asus / Computer Equipment / Server

Asus AP3000 • 4-8. Five-Tray Hot-SwapBay, • 4-9. Three-Tray Hot-SwapBay, Levers, Levers

1 42

Download 42 pages, 912.57 Kb

IV. Hardware Setup

• 4-8. Five-Tray Hot-Swap Bay

Maximum uptime in a server requires devices that can be easily replaced or “swapped.” The main hard drives are mounted in internal hot-swap trays for easy replacement. The AP3000 hot-swap bay has two different models: Five-tray hot-swap bay and three-tray hot-swap bay. The 1.0 inch SCA hot-swap bay can accommodate five 1.0 inch hard disk drives.

Setup Hardware .IV

Bay Swap-Hot

LEDs

LEDs	Levers
LEDs
Green:	Power LED
Yellow:	Hard Disk Access LED
Red:	Hard Disk Status LED (reserved)

(For details about LEDs, see p. 31.)

• 4-9. Three-Tray Hot-Swap Bay

The 1.6 inch SCA hot-swap bay can accommodate three 1.6 or 1.0 inch hard disk drives.

LEDs

Levers

IMPORTANT

Each SCA hot-swap bay provides an aluminum carrier only for a single SCSI hard disk drive.

28	AP 3000 Hardware Reference Guide

Contents

Page Page ASUSTeK COMPUTER INC. (Asia-Pacific) ASUS COMPUTER INTERNATIONAL (America) ASUS COMPUTER GmbH (Europe) I. Introduction II. Components III. Basic Operation IV. Hardware Setup Page Federal Communications Commission Statement Canadian Department of Communications Statement •1-1.How this Manual is Organized Symbols •1-2.Component Checklist Standard components Optional components •1-3.Features •1-4.Safeguards Operation Safety Tools Required •1-5.Electrical Safety Page •2-1.Server Front Side •2-2.Server Back Side •2-3.Server Left Side •3-1.Starting the Server • 3-2.LEDs • 3-3.BIOS Setup • 4-1.Opening the Chassis Panel Screws Removing the Right Panel Opening the Left Panel Chassis Circulation System • 4-2.Rear Cooling Fan Control Board Rear Cooling Fan Control Board Settings • 4-3.Motherboard Spacers Install the Baseboard Screws Device Cables Cable Connections • 4-4.Central Processing Unit (CPU) Install Retention Mechanisms Mechanism Brace Bars Install Cartridge Lifters Mechanism Cap Frame • 4-5.Chassis Intrusion Switch Intrusion Connector • 4-6.Expansion Cards • 4-7.Fixed Storage Devices Floppy Drive and CD-ROM Fixed Storage Device Tray Fixed Device Bay Cover Clips Storage Device • 4-8. Five-Tray Hot-SwapBay • 4-9. Three-Tray Hot-SwapBay Hot-SwapTray Hot-SwapBay • 4-10.Front Cooling Fans Front Cooling Fan Control Board Hard Disk Drive Message Board • 4-11.SCSI Backplane • 4-12.SCSI ID Setting SCSI ID Dip Switches SCSI ID Dip Switches (Cont’) • 4-13.Expansion Card Guide Securing Expansion Card Guide • 4-14.SCSI Termination • 4-15.Power Supply Power Supply Mounting Power Supply Information • 4-16.Power Supply Requirement Power Supply Requirement Calculation Table Page i.SCSI Cable Limits ii. Glossary Peripherals POST (Power On Self Test) PS/2 Port RAID (Redundant Array of Inexpensive Disks) RAM (Random Access Memory) (This page was intentionally left blank.)