V.Appendix
i.SCSI Cable Limits
SCSI cables have a limit to the length that it may have. Exceeding the length may cause problems mounting or using any one of the SCSI devices.
CAUTIONExceeding the SCSI cable limits may cause unreliable data transfers even if all the devices are mounted properly.
Cable Limits | Max Data Transfer Rates | Max Devices | |||
1) | 12m (29.4ft) |
| 15 | ||
2) | 3m | - 1.5m | Wide | 4 - 8 | |
3) | 3m | (9.8ft) |
| 15 | |
4) | 3m | - 1.5m | Narrow | 4 - 7 | |
5) | 3m | (9.8ft) | Narrow | 7 |
• Narrow refers to 50 pin and Wide refers to 68 pin. Don’t get confused by the width of the connector or cable.
•The SCSI ID for devices on one connector cannot be the same as the SCSI ID for devices on the other connectors. None of the devices on any connector can use ID7, which is reserved for the SCSI controller.
•A maximum of15 devices may be connected to the motherboard (three connectors) at one time.
NOTE• A total of15
•If connecting Fast/Ultra devices with Ultra2 devices on the Ul- tra2 connector, the entire SCSI bus will be limited to the Ultra SCSI conditions listed above. Mixing SCSI devices is highly not recommended.
•A total of8 “Wide
•A total of15
•A total of 7 “Narrow
•A total of7 “Narrow Fast SCSI” devices
SCSI Cable Limits
V. AppendixAP3000 Hardware Reference Guide | 39 |