Asus E2938 manual Xxxxxxxxxxxx

4.The Disks item is highlighted, press <Enter> to select the hard disk drives to configure as RAID. The following pop‑up screen appears.

			[ SELECT DISKS ]
Port Drive Model			Serial #	Size Status
	0	XXXXXXXXXXXX	XXXXXXXX	XX.XGB Non-RAID Disk
1		XXXXXXXXXXXX	XXXXXXXX	XX.XGB Non-RAID Disk
2		XXXXXXXXXXXX	XXXXXXXX	XX.XGB Non-RAID Disk
3		XXXXXXXXXXXX	XXXXXXXX	XX.XGB Non-RAID Disk

Select 2 to 4 disks to use in creating the volume.

[↑↓]-Previous/Next [SPACE]-Selects [ENTER]-Selection Complete

5.Use the up/down arrow key to highlight the drive you want to set, then press <Space> to select. A small triangle marks the selected drive. Press <Enter> after completing your selection.

6.When the Stripe Size item is highlighted, press the up/down arrow key to select the stripe size for the RAID 5 array, then press <Enter>.

The available stripe size values range from 4 KB to 128 KB. The default stripe size is 64 KB.

TIP: We recommend a lower stripe size for server systems, and a higher stripe size for multimedia computer systems used mainly for audio and video editing.

7.Key in the RAID volume capacity that you want, then press <Enter> when the Capacity item is highlighted. The default value indicates the maximum allowed capacity.

8.Press <Enter> when the Create Volume item is highlighted. This warning message appears.

WARNING: ALL DATA ON SELECTED DISKS WILL BE LOST.

Are you sure you want to create this volume? (Y/N):

9.Press <Y> to create the RAID volume and return to the main menu or <N> to go back to the Create Volume menu.

5-36 Chapter 5: Software support