6 . CPU and system fan connectors
The fan connectors support cooling fans of 350 mA ~ 740 mA (8.88 W max.) or a total of 2.1 A ~ 4.44 A (53.28 W max.) at +12V. Connect the fan cables to the fan connectors on the motherboard, making sure that the black wire of each cable matches the ground pin of the connector.
Do not forget to connect the fan cables to the fan connectors. Insufficient air flow inside the system may damage the motherboard components. These are not jumpers! Do not place jumper caps on the fan connectors!
CPU_FAN1
| GND |
| FANPWR2 |
| Rotation |
| FANOUT4 |
| REAR_FAN1 |
| Rotation +12V GND |
FRNT_FAN1 |
GND
+12V
Rotation
CPU_FAN2
GND
FANPWR3
Rotation
FANOUT6
REAR_FAN2
GND +12V Rotation
FRNT_FAN2
GND
+12V
Rotation
This connector is for additional USB 2.0 ports. Connect the USB module cable to this connector, then install the module to a slot opening at the back of the system chassis.
Never connect a 1394 cable to the USB connectors. Doing so will damage the motherboard!
NC
GND
USB_P4+
USB_P4-
USB+5V
USB34 
GND
USB_P3+
USB_P3-
USB+5V
The USB port module is purchased separately.
2 - 30 | Chapter 2: Hardware information |