5.4.6Chipset Configuration

The Chipset Configuration menu allows you to change the advanced chipset settings. Select an item then press <Enter> to display the sub-menu.

Advanced

BIOS SETUP UTILITY

Advanced Chipset Settings

WARNING: Setting wrong values in below sections may cause system to malfunction.

North Bridge Configuration

South Bridge Configuration

Configure North Bridge features.

North Bridge Configuration

 

 

 

 

BIOS SETUP UTILITY

 

 

 

Advanced

 

 

 

North Bridge chipset Configuration

ENABLE: Allow

 

 

 

 

 

remapping of

Memory Remap Feature

[Enabled]

overlapped PCI memory

 

PCI MMIO Allocation: 4GB To 3584MB

 

above the total

DRAM Frequency

[Auto]

physical memory.

Configure DRAM Timing by SPD

[Enabled]

 

Initiate Graphic Adapter

[PEG/PCI]

DISABLE: Do not allow

remapping of memory.

 

 

 

 

 

PEG Port Configuration

 

 

 

PEG Port

[Auto]

 

Memory Remap Feature [Enabled]

Allows you to enable or disable the remapping of the overlapped PCI memory above the total physical memory. Enable this option only when you install 64-bit operating system.

Configuration options: [Disabled] [Enabled]

DRAM Frequency [Auto]

Allows you to set the DDR operating frequency.

Configuration options: [Auto] [667 MHz] [800 MHz]

Configure DRAM Timing by SPD [Enabled]

When this item is enabled, the DRAM timing parameters are set according to the DRAM SPD (Serial Presence Detect). When disabled, you can manually set the DRAM timing parameters through the DRAM sub-items.

Configuration options: [Enabled] [Disabled]

Initiate Graphic Adapter [PEG/PCI]

Allows you to select the graphics controller as the primary boot device. Configuration options: [PCI/PEG] [PEG/PCI]

PEG Port Configuration

PEG Port [Auto]

Configuration options: [Auto] [Disabled]

5-20

Chapter 5: BIOS setup