SETUP H/W .3

Settings Motherboard

3.HARDWARE SETUP

3.Keyboard Power Settings (3-pin KBPWR)

This jumper allows you to enable or disable the keyboard wake-up feature. Set this jumper to pins 2-3 (5VSB) if you wish to wake up the computer when you press a key on the keyboard. This feature requires an ATX power supply that can supply at least 1A on the +5VSB lead, and a corresponding setting in the BIOS (see section 4.5.1 Power Up Control).

TR-DLS

KBPWR

 

 

3

2

2

1

 

5V5VSB (Default)

TR-DLS Keyboard Power Setting

4.Clear RTC RAM (CLRCMOS)

These two solder points allow you to clear the RTC RAM in CMOS. You can clear the CMOS memory of date, time, and system setup parameters by erasing the CMOS Real Time Clock (RTC) RAM. The RAM data that include system setup information, such as system passwords, is powered by the onboard button cell battery.

To erase the RTC RAM:

1.Turn OFF the computer and unplug the power cord.

2.Remove the battery.

3.Short the solder points for a few seconds.

4.Re-install the battery.

5.Plug the power cord and turn ON the computer.

6.Hold down the <Del> key during the boot process and enter BIOS setup to re-enter CMOS data.

TR-DLS

CLRCMOS

PCI3 (32-bit, 33MHz 5V)

 

 

 

 

 

 

 

 

PCI4 (32-bit, 33MHz 5V)

Short solder points

 

to Clear CMOS

 

TR-DLS Clear RTC RAM

22

ASUS TR-DLS User’s Manual