4.Plug the chassis fan cable to the connector on the motherboard.

2.10.2HDD blower

To remove the HDD blower:

1.Remove the side cover. Refer to section “2.1.1 Removing the side cover” for

 

instructions.

3

2.

 

Disconnect the 3-pin fan cable from the fan connector on the backplane.

3. Loosen the thumb screw that secures the HDD blower case to the chassis.

4. Firmly grip the blower case as shown, then slide it out of the chassis in the direction of the arrow until the tabs are released from the holes of the HDD cage.

2-32

Chapter 2: Hardware setup