12.Power supply SMBus connector (5-pin PSUSMB1)

This connector is for the power supply SMB cable, if your power supply supports the SMBus function.

LAN2

PSU_I2CCLK PSU_I2CDATA NC GND +3.3V Remote Sense

PSUSMB1

P5MT Series Power supply SMBus connector

13.SSI power connectors (24-pin ATXPWR1, 8-pin ATX12V2)

These connectors are for SSI power supply plugs. The power supply plugs are designed to fit these connectors in only one orientation. Find the proper orientation and push down firmly until the connectors completely fit.

• Use of an SSI 12 V Specification 2.0-compliant power supply unit (PSU) that provides a minimum power of 450 W is recommended for a fully- configured system.

•By default, four ATX12V2 connector pins are covered to prevent incorrent insertion of a 4-pin ATX +12V power plug. Remove this cover when using a PSU with an 8-pin ATX +12V power plug.

•Do not forget to connect the 4-pin or 8-pin ATX +12 V power plug; otherwise, the system will not boot up.

•Use of a PSU with a higher power output is recommended when configuring a system with more power consuming devices. The system may become unstable or may not boot up if the power is inadequate.

•You must install a PSU with a higher power rating if you intend to install additional devices.

 

 

 

ATXPWR1

 

 

 

 

 

 

 

24-pin Power Connector

ATX12V2

 

+3Volts

+3Volts

Ground +5Volts

Ground +5Volts

Ground PowerOK

+5VStandby

+12Volts

+12Volts

+3Volts

LAN2

GND GND GND GND

 

1

 

Ground PSON#

 

 

 

 

 

 

 

 

+3 Volts

-12 Volts

Ground Ground

Ground -5 Volts

+5 Volts

+5 Volts

+5 Volts

Ground

+12VDC +12VDC +12VDC +12VDC

P5MT Series ATX power connectors

 

 

 

 

 

 

 

4-16

 

 

 

 

Chapter 4: Motherboard information