2.10.3 SATA/SAS backplane

To remove the SATA/SAS backplane:

1.Remove the HDD blower case. Refer to section “2.10.2 HDD blowers” for instructions.

2.Disconnect all cables from the SATA/SAS backplane.

When disconnecting a cable, hold and firmly pull the cable plug. DO NOT pull the cable itself. Doing so may damage the cable!

3.From the inner edge, push the backplane outward so that the outer edge protrudes slightly from the slot.

4.From the outer edge, firmly hold the backplane and carefully slide it out.

2-36

Chapter 2: Hardware setup