Memory System

.3 SETUP H/W

3.HARDWARE SETUP

3.5System Memory (DIMM)

NOTE: No hardware or BIOS setup is required after adding or removing memory.

This motherboard uses only Dual Inline Memory Modules (DIMMs). Sockets are available for 3.3Volt (power level) unbuffered Synchronous Dynamic Random Access Memory (SDRAM). One side (with memory chips) of the DIMM takes up one row on the motherboard.

Memory speed setup is possible through BIOS, Section 4.4.1 Chip Configuration.

Install memory in any combination as follows:

DIMM Location

168-pin DIMM

 

Total Memory

 

 

 

 

Socket 1 (Rows 0&1)

SDRAM 8, 16, 32, 64, 128, 256, 512MB

x1

 

 

 

 

 

Socket 2 (Rows 2&3)

SDRAM 8, 16, 32, 64, 128, 256, 512MB

x1

 

 

 

 

 

Socket 3 (Rows 4&5)

SDRAM 8, 16, 32, 64, 128, 256, 512MB

x1

 

 

 

 

 

 

Total System Memory (Max 512MB)

=

 

 

 

 

 

NOTE: Make sure the total installed memory does not exceeds 512MB. Otherwise, the system may hang during startup.

3.5.1 General DIMM Notes

•ASUS motherboards support SPD (Serial Presence Detect) DIMMs. This is the memory of choice for best performance vs. stability.

•BIOS shows SDRAM memory on bootup screen.

•Single-sided DIMMs come in 16, 32, 64,128, 256MB; double-sided come in 32, 64, 128, 256, 512MB.

24

ASUS TUSL2-C User’s Manual