Asus TUSL2-C 23)ATX Power Supply Connector (20-pinblock ATXPWR), 24)Power Supply Thermal Sensor Connector (2-pinJTPWR)

.3

H/WConnectors

SETUP

3.HARDWARE SETUP

23)ATX Power Supply Connector (20-pin block ATXPWR)

This connector attaches to an ATX power supply. The plug from the power supply will only insert in one orientation because of the different hole sizes. Find the proper orientation and push down firmly making sure that the pins are aligned.

IMPORTANT: Make sure that your ATX power supply at least 10mA (750mA recommended) on the +5-volt standby lead (+5VSB). Your system may become unstable/unreliable and may experience difficulty in powering up if your power supply is inadequate. For Wake-On-LAN support, your ATX power supply must supply at least 750mA +5VSB.

+12.0	Volts	+5.0 Volts
+5V Standby		+5.0 Volts
Power Good		-5.0 Volts
Ground		Ground
+5.0	Volts	Ground
Ground		Ground
+5.0	Volts	Power Supply On
Ground		Ground
+3.3	Volts	-12.0 Volts
+3.3	Volts	+3.3 Volts

TUSL2-C

TUSL2-C ATX Power Connector

24)Power Supply Thermal Sensor Connector (2-pin JTPWR)

If you have a power supply with thermal monitoring, connect its thermal sensor cable to this connector.

	JTPWR
TUSL2-C	Power Supply
	Thermal Sensor

TUSL2-C Thermal Sensor Connector

40 ASUS TUSL2 User’s Manual