4.1 Managing and Updating Your BIOS

4.1.1 Upon First Use of the Computer System

It is recommended that you save a copy of the original motherboard BIOS along with a Flash Memory Writer utility (AFLASH.EXE) to a bootable floppy disk in case you need to reinstall the BIOS later. AFLASH.EXE is a Flash Memory Writer utility that updates the BIOS by uploading a new BIOS file to the programmable flash ROM on the motherboard. This file works only in DOS mode. To determine the BIOS version of your mother- board, check the last four numbers of the code displayed on the upper left- hand corner of your screen during bootup. Larger numbers represent a newer BIOS file.

1.Type FORMAT A:/S at the DOS prompt to create a bootable system disk. DO NOT copy AUTOEXEC.BAT and CONFIG.SYS to the disk.

2.Type COPY D:\AFLASH\AFLASH.EXE A:\ (assuming D is your CD- -ROM drive) to copy AFLASH.EXE to the boot disk you created. NOTE: AFLASH works only in DOS mode. It does not work in the DOS prompt within Windows and does not work with certain memory drivers that may be loaded when you boot from the hard drive. It is rec- ommended that you reboot using a floppy disk.

3.Reboot the computer from the floppy disk.NOTE: BIOS setup must specify “Floppy” as the first item in the boot sequence.4. In DOS mode, type A:\AFLASH <Enter> to run AFLASH.

IMPORTANT! If the word “unknown” appears after Flash Memory:, the memory chip is either not programmable or is not supported by the ACPI BIOS and therefore, cannot be programmed by the Flash Memory Writer utility.

Updating BIOS

4. BIOS SETUP

ASUS TUSL2-C User’s Manual

45