About this guide
Audience
This user guide is intended for system integrators and experienced users with at least basic knowledge of configuring a workstation.
Contents
This guide contains the following parts:
1.Chapter 1: Product Introduction
This chapter describes the general features of the workstation, including sections on front panel and rear panel specifications.
2.Chapter 2: Hardware setup
This chapter lists the hardware setup procedures that you have to perform when installing or removing system components.
3.Chapter 3: Motherboard information
This chapter gives information about the motherboard that comes with the workstation. This chapter includes the motherboard layout, jumper settings, and connector locations.
4.Chapter 4: BIOS information
This chapter tells how to change system settings through the BIOS Setup menus and describes the BIOS parameters.
5.Chapter 5: RAID configuration
This chapter provides information on how to configure your hard disk drives as RAID sets.
6.Chapter 6: Driver installation
This chapter provides information on how to install the drivers for system components. This chapter also describes the software applications that the barebone workstation supports.
7.Appendix: Reference information
This section provides information about the CPU features and technologies and a troubleshooting guide for solving common problems when using the barebone workstation.