4.3Replacing the cable connections of other
devices
You can also use the WL-330g to replace your Xbox, PlayStation® 2, or set-top box network cable connection.
To do this:
1.Switch the WL-330g to Ethernet adapter mode using the mode switch. (Default SSID: ANY)
2.Place the WL-330g nearest the AP you wish to connect, then turn on the device.
3.Connect one end of the supplied RJ-45 cable to the Ethernet port of the device and the other end to the Xbox, PlayStation® 2, or set-top box Ethernet port.
4.Set the IP address of the Xbox, PlayStation® 2, or set-top box to establish connection to the local network. Verify your connection.
Make sure the WL-330g MAC cloning feature is enabled when using the device in this setup. Use the Wireless Setting Utility to enable MAC cloning. See page 3-24 for details on MAC cloning.
4.4Sharing Internet connection with other
computers
Refer to the typical network configuration below and a table on the next page for information on Internet connection sharing with other computers in your office or home network.
Internet | ADSL/Cable modem WL-330g | Wireless computer |
Use the mode switch to set the WL-330g to AP mode before sharing an Internet connection with other computers in your network.
ASUS Pocket Wireless Access Point (WL-330g) | 4-3 |
