INSTALLATION .III

Connectors

III.INSTALLATION

13.Message LED Lead (2-pin MSG.LED)

This indicates whether a message has been received from a fax/modem. The LED will remain lit when there is no signal and blink when there is data being trans- ferred or waiting in the inbox. This function requires ACPI OS and driver support.

14.SMI Suspend Switch Lead (2-pin SMI)

This allows the user to manually place the system into a suspend mode or “Green” mode where system activity will be decreased to save electricity and expand the life of certain components when the system is not in use. This 2-pin connector (see figure below) connects to the case-mounted suspend switch. If you do not have a switch for the connector, you may use the “Turbo Switch”. SMI is acti- vated when it detects a short to open moment and therefore leaving it shorted will not cause any problems. This may require one or two presses depending on the position of the switch.

15.ATX Power Switch / Soft Power Switch (2-pin PWR)

The system power is controlled by a momentary switch connected to this lead. Pressing the button once will switch the system between ON and SLEEP. Press- ing the switch while in the ON mode for more than 4 seconds will turn the system off. The system power LED shows the status of the system’s power.

16.Reset Switch Lead (2-pin RESET)

This 2-pin connector connects to the case-mounted reset switch for rebooting your computer without having to turn off your power switch. This is a preferred method of rebooting to prolong the life of the system’s power supply.

17.System Power LED (3-pin KEYLOCK)

This 3-pin connector connects the system power LED, which lights when the system is powered on and blinks when it is in sleep mode.

18.Keyboard Lock Switch Lead (2-pin KEYLOCK)

This 2-pin connector connects to the case-mounted key switch to allow key- board locking.

19.Speaker Connector (4-pin SPEAKER)This 4-pin connector connects to the case-mounted speaker.

X G - D L S

XG-DLS Panel Connectors

Keyboard Lock

Speaker

Power LED

 

Connector

Keylock Ground

 

Ground Ground Speaker

+5 V

PLED

+5V

+5 V

TB LED

ExtSMI# Ground PWR +3VSB

Reset Ground

MessageLED

 

 

Reset SW

 

ATX Power

SMI Lead

 

 

 

 

Switch*

*Requires an ATX power supply.

32

ASUS XG-DLS User’s Manual