III.INSTALLATION

20.Chassis Intrusion Sensor Lead (4-1 pin CHASSIS)

This lead is for a chassis intrusion monitor or sensor. The sensor is triggered when a high level signal is sent to the “chassis signal” lead. This occurs when a panel switch or light detector is triggered. This function requires optional trig- ger switches to be installed.

CHASSIS

X G - D L S

Ground

Chassis

+5VSB

XG-DLS Chassis Open Alarm Lead

21.Wake-On-LAN Connector (3-pin WOLCON)

These connector connects to LAN cards with a Wake On LAN output, such as the ASUS PCI-L101. The connector powers up the system when a wakeup packet or signal is received through the LAN card.

IMPORTANT: This feature requires that the WAKE On LAN Power Up Con- trol is set to Enabled (see “Power Management Setup” under BIOS SOFT- WARE section) and that your system has an ATX power supply with at least 720mA +5V standby power.

INSTALLATION

Connectors

III.

 

 

 

X G - D L S

Ground

+5 Volt Standby

PME

IMPORTANT: Requires an ATX power supply with at least 720mA +5Volt standby power

ASUS XG-DLS User’s Manual

33