Getting started
Telephone base and charger installation
Install the telephone base and charger as shown below.
The telephone base is ready for tabletop use. If you want to change to wall mounting, see Installation options on page 8 for details.
Telephone base installation
•Plug the other end of the telephone line cord into a telephone jack or a DSL filter.
•Raise the antenna.
• Plug one end of the
| telephone line cord |
| into the telephone jack |
| on the bottom of the |
| telephone base. |
• Plug the small end of | |
| the telephone base |
| power adapter into the |
| power adapter jack |
| on the bottom of the |
| telephone base. |
• | Route the power |
| adapter cord through |
Telephone line cord | this slot. |
| |
• Place the cords into | |
Power | the channels. |
adapter |
|
• Plug the large end | |
If you have DSL high- speed | of the power adapter |
into a power outlet | |
Internet service, a DSL filter | not controlled by a |
(not included) is required. | |
wall switch.
Charger installation
Plug the power adapter into an electrical outlet
not controlled by a wall switch.
IMPORTANT INFORMATION
1.Use only the power adapter(s) supplied with this product. To order a replacement power adapter, visit our website at www.telephones.att.com or call
1 (800) 222-3111. In Canada, dial 1 (866) 288-4268.
2.The power adapters are intended to be correctly oriented in a vertical or floor mount position. The prongs are not designed to hold the plug in place if it is plugged into a ceiling,
