AT&T CL84109, CL84209, CL84309

Telephone settings

Answering system settings (handset only)

To delete your outgoing announcement:

1. When the handset is in idle mode, press MENU/SELECT to enter the main

menu.

2. Press MENU/SELECT again.

3. Press qCID or DIRp to scroll to >ANS SYS SETUP, then press

MENU/SELECT.

4. Press qCID or DIRp to scroll to >ANNOUNCEMENT, then press

MENU/SELECT, the system announces, “To play, press 2. To record, press 7.”

5. Press 3 to delete your recorded announcement. The system announces

“Announcement deleted.”

When your announcement is deleted, the system answers calls with the pre-

recorded announcement described on the previous page.

Number of rings

You can set the answering system to answer an incoming call after two, four,

or six rings. You can also select toll saver, which is explained below. Unless you

change it, the answering system answers an incoming call after four rings.

To set the number of rings on a cordless handset:

1. When the handset is in idle mode, press MENU/SELECT to

enter the main menu.

2. Press MENU/SELECT again.

3. Press qCID or DIRp to scroll to >ANS SYS SETUP, then

press MENU/SELECT.

4. Press qCID or DIRp to scroll to ># OF RINGS, then press

MENU/SELECT.

5. Press qCID or DIRp to scroll and choose among 2, 4, 6 or

TOLL SAVER.

Toll saver - the answering system answers a call after two

rings if you have new messages, and after four rings when

there are no new messages. This feature allows you to check

for new messages and avoid paying long distance charges

when calling from out of your local area.

6. Press MENU/SELECT to confirm your setting. A confirmation

tone sounds.

NOTE: If you subscribe to voicemail services through your telephone service provider, see

Answering system and voicemail on page 55.

ANS. SYSTEM