AT&T TL30100, TL32300, TL32100, TL32200 Battery charging, charging. See Technical specifications on

Battery status icon

Getting started

Battery installation and charging

Battery charging

Once you have installed the battery, the screen indicates the battery status (see the table below). If necessary, place the handset in the charger to charge the battery.

For best performance, keep the handset in		HANDSET 1
the charger when not in use. The battery is
fully charged after 16 hours of continuous
charging. See Technical specifications on	10:30PM		11/20
page 33 for battery operating times.

If the screen is blank, you need to charge

the handset without interruption for at least 30 minutes to give the handset enough charge to use the telephone for a short time. The screen shows Low battery until you have charged the battery without interruption for at least 30 minutes. The following table summarizes the battery charge indicators and actions to take.

		Battery indicators			Battery status	Action
The screen is blank or					Battery has no or	Charge without
shows					very little charge. The	interruption until the
Place in charger.					handset cannot be used.	screen shows
						Low battery or
						HANDSET X (at least
						30 minutes).
The screen shows					Battery has enough	Charge without
Low battery and					charge to be used for a	interruption until the
					short time.	screen shows
flashes.
						HANDSET X (at least
						30 minutes).
The screen shows					Battery is charged.	To keep the battery
HANDSET X and the						charged, place it in the
battery icon shows						charger when not in use.
	,		or	.