ATEN Technology ACS-1208AL, ACS-1216AL Keyboard 5.Power LED, Slide Release, Reset Switch

Introduction

Note: 1. Since the ACS-1208AL only has eight ports, only the top row of LEDs (corresponding to Ports 1 - 8) are active on that unit. On the ACS-1216AL, both rows are active.

2.When the ACS-1208AL / ACS-1216AL is first powered on, the On Line and Selected LEDs blink one after the other as the Switch performs a self-test.

4.Keyboard

5.Power LED

Lights BLUE to indicate that the unit is receiving power.

6.Slide Release

For convenience and to prevent inadvertent damage to the console, the ACS-1208AL / ACS-1216AL has a mechanism that locks it in the “In” position to prevent it from accidentally sliding out. In order to slide the the console out, you must first release it by moving this tab sideways.

7.Rack Mounting Brackets

There are rack mounting brackets attached to each corner of the unit. They are used to secure the chassis to a system rack. Refer to Appendix C for rack mounting details.

8.Touchpad

9.LCD Display Controls

The LCD On/Off Switch is located here, as well as buttons to control the position and picture settings of the LCD display. See the LCD OSD Configuration section p. 1-10, for details.

10.Reset Switch

Pressing this switch in performs a system reset. This switch is recessed and must be pushed with a thin object - such as the end of a paper clip, or a ballpoint pen.

1-7

2003-01-28