Chapter 7. The Firmware Upgrade Utility
3.From your KVM switch console, bring up the OSD (see page 23) and select the F4ADM function.
4.Scroll down to FIRMWARE UPGRADE. Press [Enter].
5.Press [Y] to invoke Upgrade mode.
6.Proceed with the firmware upgrade as described in Performing the Upgrade, starting on page 53.
7.When the upgrade ends, power off the switch
8.Slide the Firmware Upgrade Recovery Switch back to the Normal position.
9.Power on the switch.
Note: If one of the child KVM units fails to upgrade successfully, unchain it from the installation and perform the recovery and upgrade operation on it independently. After it has been successfully upgraded, plug it back into the chain
Adapter Cable Firmware Upgrade Recovery
To perform an adapter cable firmware upgrade recovery, do the following:
1.Unplug the adapter cable from the computer it is connected to.
2.Slide its Firmware Upgrade Recovery Switch (located next to the RJ45 connector) to the Recover position.
3.Plug the adapter cable back into the computer.
4.From your KVM switch console, bring up the OSD (see page 23) and select the F4ADM function.
5.Scroll down to FIRMWARE UPGRADE. Press [Enter].
6.Press [Y] to invoke Upgrade mode.
7.Proceed with the firmware upgrade as described in Performing the Upgrade, starting on page 53.
8.After the upgrade completes and the switch restarts, unplug the adapter cable from the computer and slide the Firmware Upgrade Recovery Switch back to the Normal position.
9.Plug the adapter cable back into the computer.
57