PN9108 User Manual

Dial Out Connection

This configuration sets up a connection for the PN9108 to an ISP's site. You can use the dynamic IP address that the ISP assigns to the PN9108 to access it with a browser.

Connection Setup

1. Set up your hardware configuration to match the diagram, below:

PN9108ISP

Phone Line

Serial Cable

Modem

Note: Use a standard 9 pin serial modem cable to connect the modem to the PN9108's RS-232 port.

2.In the Out of Band Configuration dialog box (see page 45):

a)Make sure that the Enable dial-out function setting is enabled (there is a check mark in the box).

b)Fill in the Com Port, ISP, and Modem settings with values appropriate for connecting to your ISP.

Note: 1. If your modem isn't in the drop down list, select Generic Modem as the modem type.

2.If you choose Generic Modem, you must specify any necessary initialization commands in the Initialization String textbox. The commands should be separated by a semicolon ( ; ). If you leave the initialization string blank, the PN9108 will only issue the atdt command.

62