Chapter 3. Local Operation

Video In Selection

To select which input source displays on each output port, do the following:

1.Use the Out dial and turn it clockwise (right) or counterclockwise (left) to select an input port.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

OUTPUT

01

02

03

04

05

06

07

08

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

INPUT

02

02

05

05

01

01

03

04

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

2.When the cursor is on your selected input port, use the In dial and turn it clockwise (ascending from 1, 2 .... 16, NA) or counterclockwise (descending from 1, NA, 16 .... 2) to cycle through the available input sources.

Options are Ports 1–16 and NA (none).

3.Press In/Out/Enter to confirm your selection. The audio, video, and RS- 232 signals from the selected input port are now tied to the selected output port.

4.Repeat steps 1–3 for all required ports.

Note: 1. This operation ties all three signals (audio, video, serial) from a selected input to a selected output.

2.If you did not make any changes, press ESC pushbutton to return to the Main Screen.

19