ATEN Technology VM1616T Save/Load Profile Commands

Chapter 5. RS-232 Commands

Save/Load Profile Commands

The formulas for Save/Load Profile commands are as follows:

1. Command + Profile + Number + Address + Number + Control + [Enter]

For example, to save the current connection configuration to profile 12 on device 01, type the following:

profile f 12 a01 save [Enter]

2. Command + Profile + Number + Address + Number + Control + [Enter]

For example, to load profile 12 on device 01, type the following: profile f 12 a01 load [Enter]

The following tables show the possible values for commands:

	Profile	Description

	f	Profile


	Command	Description

	profile	Save / Load profile


	Profile	Description
	Number	Description
	Number

	yy	00-31 (default is 00)


	Address	Description

	a	Device address


	Device	Description
	Number	Description
	Number

	zz	00-15 (default is 00)

	*	All devices


	Control	Description

	save	Save the current connection
		configuration

	load	Load a saved profile

Contents

Page FCC, CE Information RoHS Safety SJ/T User Information Online Registration Telephone Support User Notice Package Contents Contents 1. Introduction 2. Hardware Setup 3. Local Operation 4. Remote Operation 5. RS-232Commands Appendix About this Manual Conventions Product Information Page Introduction Overview Features Requirements Transmitters Receivers Local Output Cables Source Device Operating Systems Components Front View Rear View Hardware Setup Rack Mounting Page Grounding Page Cable Connection Installation Diagram A Installation Diagram B Page Local Operation Front Panel Operation Basic Navigation Menu Organization Enter Password Main Screen Video In Selection Set IP Port Subnet Mask Gateway Default IP Settings Save and Reset / Exit Set Serial Port Baud Rate Serial Port Mode Adjust Video Level Adjust Audio Level Save / Load Profile Security Mode Switch Audio Only Page Remote Operation Logging In Connections Page Toolbar Configuring Connections Save / Load Connection Profiles Operation Type Viewing Port Information Optimizing Video Adjust Audio Setup IP Setup Serial Setup Port Name Firmware Profile Selection Name User Management Password Privileges Telnet Operation Configuration Menu 2. GT – Set gateway address 3. IM – Set IP subnet mask 4. IP – Set IP address 5. LO – Load connections from profile 6. PW – Change password 9. SB – Set serial port baud rate 10. SS – Switch input to specified output 12. SV – Save the current connection to a profile 13. TI – Set timeout 14. VR – Software version information RS-232Commands RS-232Serial Interface Configuring the Serial Port RS-232Control Tool Switch Port Commands Audio Video Mute Commands Save/Load Profile Commands Adjust Video Quality Commands Adjust Audio Commands Verification Appendix Safety Instructions General Page Rack Mounting Technical Support International North America Specifications Troubleshooting Limited Warranty