27
Lighting the Grill Using the Piezo Ignitor (continued)
1.Open the Hood.
2.IMPORTANT: Make sure Control Knobs are turned “Off.” (Fig. 4)
3.Turn the LP Gas Cylinder valve open counterclockwise until it stops. (Fig. 5)
|
| Turn LP Gas |
| Control Knob in High | Cylinder valve |
Control Knob in | counterclockwise | |
position (large flame | Fig. 5 | |
Off position | symbol) |
|
Fig. 4 |
|
|
Side Burner
Control Knob
Piezo Igniter Button 
Fig. 6 | Left Main Burner |
Control Knob |
Right Main Burner
Control Knob
4.Push far left Main Burner Control Knob in on Control Panel and turn counterclockwise to the High position. (Figs. 4 and 6)
5.Push the Piezo Igniter Button several times so that it clicks each time. Look to make sure the Burner is lit. If no spark, see Troubleshooting Section on page 37.
6.From the “Off” position, light other Burner. Your grill has a Crossover Ignition System that allows the Burners to light successively off one another.
7.If the Burner fails to light, repeat Step 4. If it still does not light, try the right Burner.
If a Burner goes out during operation, turn all Control Knobs to the “Off” position and close the LP Gas Cylinder valve to dissipate any accumulated gas. Open Hood and wait five minutes before attempting to relight the grill.
If any or all Burners fail to light after three to four attempts following Steps
NOTE: If the Burners still fail to light, refer to the Troubleshooting Section on page 38. The Burner can also be lit manually, see
