21
8. If “growing” bubbles appear on any of the connection points, you have detected a gas leak . Immediately close the
LP Gas Cylinder valve by turning handle clockwise
a. If leak appears at either end of hose and regulator assembly, retighten the connection at the leak, but do not
over-tighten. (NOTE: Only hand tighten at coupling nut in Fig. 3 shown on previous page) Repeat Leak Test.
b. If the leak is coming from the Gas Cylinder, from the valves at the Control Knobs, or if the leak cannot be
stopped, do not use the grill. Call Customer Service at 1-800-251-7558. Be sure to have the grill model
number and serial number printed on the blac k label, located inside the left door of the cabinet. If you
need a replacement part under w arranty, a proof of purchase will be nece ssary.
9. Upon completion of leak test, turn all Control Knobs to the “Off” position. Turn the handle on the LP Gas Cylinder
clockwise until it stops. Disconnect LP Gas Cylinder by tur ning coupling nut on regulator in a counterclockwise
direction until regulator is released from threaded LP Gas Cylinder nozzl e.
10. Place the protective cap over LP Gas Cylinder nozzle.
11. Re-attach the wire leads to the Igniter Button. Replace Control Panel around flanges at Bowl ends and align bolt
holes on each side. Replace and retighten all bolts. (Fig. 1)
Should you notice that your Burner(s) are getting hard to light or the flame is not as hot as it once was, refer to the
“How to Clean your Burners” s ection on page 31, to remove any possible obstructions.
Lighting the Grill Using the Pulse-Spark Ignitor
To reduce the risk of death or serious injury from an explosion or a fire beneath the grill:
• Inspect and c lean Burner/Venturi Tubes for insects or insect nests. Spiders or small in sects can build nests, webs, and
lay eggs in the grill’s Venturi Tubes, (Fig 15 - page 31) obstructing the flow of gas to the Burner. The backed-up gas
can ignite behind the Control Panel and cause a fire beneath the grill, posing the risk of death or serious bodily injur y.
This is known as a “flashback.”
• Be sure Burners are re-installed properly before using grill.
WARNING
!