26

Manually Lighting the Side Burner

!WARNING

To reduce the risk of serious bodily injury or death from fire, explosion or burn hazard:

Open Side Burner Lid before lighting the grill to prevent an explosion from gas build-up.

When manually lighting Side Burner, use Match light Holder.

1.Open the Side Burner Lid.

2.IMPORTANT: Make sure Side Burner Control Knob is turned “Off” first.

3.Turn the LP Gas Cylinder valve open counterclockwise until it stops. (Fig. 8)

4.Push Side Burner Control Knob in and turn counterclockwise to the High position.

5.Hold lit Match, using Match Holder, near Burner.

6.If the Burner fails to light, repeat Steps 3-5.

If the burner fails to light after three or four attempts following Steps 3-6, turn the Side Burner Control Knob to the “Off” position and close the LP Gas Cylinder valve to dissipate an accumulated gas. Wait five minutes; then repeat the lighting procedure.

NOTE: If the Burners still fail to light, refer to Troubleshooting Section.

Hold lit match near Burner

Fig. 14

Side Burner Control Knob

 

Manually Lighting the Rotisserie Burner

NOTE: Do not operate the Sear burner and Rotisserie burner at the same time. Do not use the Rotisserie burner when main burners are in use. Remove the Warming Rack when using the Rotisserie Burner to prevent damage to the Warm- ing Rack.

1.Open lid during lighting.

2.Make sure the Rotisserie Burner Knob is in the “Off” position.

3.Turn on LP Gas Cylinder.

4.Push in and turn the Rotisserie Knob to the High position and hold in for 3-4 seconds. While holding the knob in, hold a lit match near the surface of the burner until the Burner is lit. Continue to hold the knob in for another 10- 15 seconds to allow the complete heating of the safety sensor.

5.If ignition does not occur in 5 seconds, turn the burner knob to the “Off” position and wait 5 minutes before repeating the lighting procedure.

Page 26
Image 26
Aussie 68R5A9SSS1 manual Manually Lighting the Side Burner, Manually Lighting the Rotisserie Burner