Aussie 68R5A9SSS1 manual LP Hose and Regulator, Connecting LP Gas Cylinder

LP Hose and Regulator

!WARNING

To reduce the risk of serious bodily injury or death from fire or explosion:

•Clean and inspect the gas hose/regulator before each use of the outdoor cooking gas appliance. The gas hose/regulator must be replaced prior to being used, if there is evidence of excessive abra- sion or wear, or if the hose is cut or leaks.

•Use only the gas hose/regulator assembly that has been supplied with this gas grill. Do not use hose/regulator from another manufacturer. Replacement gas hose/regulator assembly must be specified by this grill’s manufacturer before using.

•Always check for gas leaks when you connect and disconnect the hose/regulator to the LP Gas Cylinder, especially after a period of storage (for example, over winter).

•Make sure there are no sharp bends in the hose.

•Make sure the hose/regulator does not contact any heated surfaces.

17

NOTE:

If the hose/regulator assembly is not working properly and you need a replacement, contact Customer Service at 1-800-251-7558or go to www.aussiegrills.com.

Be sure to have the grill model number and serial number printed on the black label, located inside the left door of the cabinet. If you need a replacement part under warranty, a proof of purchase will be necessary. You will be asked to forward your proof of purchase via e-mail or to fax your proof of purchase to 423-639-1055 and reference your model and serial number. It is important to register your grill and retain your receipt.

Connecting LP Gas Cylinder

1.Fill empty OPD LP Gas Cylinder at your local gas supplier.

2.Place the LP Gas Cylinder in the large hole in the Bottom Panel inside the cabinet. Rotate the LP Gas Cylinder so the Cylinder nozzle is toward the door opening for proper vapor withdrawal. Lock the LP Cylinder in place by tightening wing bolt on the outside rear of the cabinet base so that it seats against the ring base of the LP Cylinder.

3.Remove the protective cap from the LP Gas Cylinder valve. (Save cap for re-capping.) Hold Regulator in a straight line with LP Gas Cylinder valve so the connection does not cross thread. Insert Regulator Nipple into the LP Gas Cylinder valve. Hand tighten coupling nut in clockwise direction. DO NOT USE TOOLS.

Wing Bolt on outside rear of cabinet base

Cylinder nozzle faces out toward door

Disconnecting LP Gas Cylinder

Hand-tighten coupling nut in clockwise direction

1.Turn all Control Knobs to the “Off” position and turn the handle on the LP Gas Cylinder clockwise until it stops.

2.Turn coupling nut on regulator counterclockwise until regulator is released from the threaded LP Gas Cylinder nozzle.

3.Place the protective cap over LP Gas Cylinder nozzle.