Operating Your Heater, Starting The Pilot Flame

OPERATING YOUR HEATER (CONTINUED) PAGE 17

Starting The Pilot Flame

The pilot flame is required to ignite the main burners (it also plays a safety role). It should be left on once lit. It will stay lit unless the gas control valve is turned to "OFF". However, the pilot will go out if the gas is shut off or if the stove malfunctions. If the pilot turns off frequently, call your dealer for information. To start the pilot follow the directions below:

NOTE: IF YOU'RE TRYING TO RE-LIGHT THE PILOT BECAUSE SERVICE WAS PERFORMED ON THE UNIT (I.E. GAS LINE REMOVED THEN RE-INSTALLED OR BECAUSE TANK RAN OUT OF GAS), FOLLOW THE INSTRUCTIONS FOR REMOVING THE DOOR ON PAGE 14 THEN BLEED THE GAS LINE.

APush the gas control knob in slightly and turn it to the "OFF" position. The knob will not turn from "ON" to "OFF" unless the knob is depressed slightly.

B Wait five minutes to let any

gas that may have

accumulated inside the

firebox escape. If you smell

gas, follow the directions on

	ON	B
	ON	5 minutes
		5 minutes

T
O	OFF
L	OFF
I
P
	PILOT ADJ

the cover "IF YOU SMELL

GAS".

C Turn the gas control knob to

the "PILOT" position and

press the knob in, this will

allow gas to flow to the pilot

light. Press the red button

on the pilot igniter

repeatedly until you see the

pilot light. KEEP THE GAS

CONTROL KNOB

DEPRESSED FOR 30

SECONDS ONCE IT IS

ON
	P
L	I
L

PILOT ADJ

Do not press knob in for more than 15 seconds if pilot does not light.

Call Your Dealer For Service

PILOT

IGNITER

LIT. NOTE: IF THE

PILOT DOES NOT

LIGHT AFTER 15

SECONDS, RELEASE

THE KNOB AND CALL

YOUR DEALER FOR

SERVICE.

DRelease the gas control knob. If the pilot goes out, repeat step C. If the pilot refuses to stay lit, call your dealer for service.

ETurn the gas control knob counter-clockwise to "ON". The pilot is now lit and the stove can be turned on and off.

ON				30 seconds
T		P
O		P
	L	I
	L
PILOT ADJ
ON			E	OFF
		?		PI
				L
				T
				O
O		P		ON
T	L	I
	L