Avalon Stoves 700 B-VENT manual Optional Equipment, Surround Panel Installation

OPTIONAL EQUIPMENT (CONTINUED) PAGE 27

Surround Panel Installation

+The surround panels come in the sizes listed below

PANEL SIZE	HEIGHT	WIDTH	PART #
8"	28"	40"	99300259
10"	30"	44"	99300260
12"	32"	48"	99300261

1The insert must be in place with the gas line and vent attached prior to installing the panels. The rear edge of the insert must be 13" behind the facing of the fireplace for the panels to fit correctly.

2Run the power cord to either side of the insert several inches in front of the facing.

3 Follow the instructions below for installing the panels and trim.

aRemove the button plugs on the side of the insert (2 on each side). Pre-thread these holes by inserting the screws (10-24 self-tapping) and tightening with a 5/16" nutdriver. Line up the holes on the side panels over the holes exposed by removing the button plugs. Attach the side panels with the screws.

bInstall the top panel so the two joggle clips slide over the tab on top of the side panels..

Top Trim
"L" Bracket	Top Trim
Top	c
Panel	Construct the panel trim.
	Insert one leg of each "L"
	bracket into the top and side
	trim piece. Align the trim to
	form a precise corner, then
	tighten the two set screws
	with a small standard
	screwdriver. Slide the trim
	over the panels. Attach a
	piece of included double-back
	tape to the bottom of each
	side trim to keep it from flaring
	at the bottom.
Side
Panel	Right Side Trim
Button Plugs	Nutdriver
(pry out with a screwdriver)	5/16"
Double-Back Tape

Tighten the set screws from the back side with a small standard screwdriver

"L" Bracket

Right Side

Trim

NOTE: Discard the insulation that comes with the surround panels (for wood stoves only). The panels must not form an air-tight seal against the fireplace.