PAGE 18 OPERATING YOUR HEATER (CONTINUED)
Starting the Heater for the First Time
¥Painted Stoves require the paint to be cured. Start the heater and burn on low for 20 minutes. Turn off and let cool. Repeat twice to fully cure the paint.
+Fumes and smoke from the paint curing and oil burning off the steel may occur the first time you start your heater. This is normal. We recommend you open windows to vent the room.
+Condensation may appear on the glass each time you start the heater - this is normal.
+Blue Flames will occur on the heater when it first comes on. After fifteen minutes the flames will turn a more realistic yellow and orange color.
?Certain installations use a remote "wall switch" to turn the heater on and off. If this is the case, leave the ON/OFF switch "ON".
Turning the Heater On and Off
After the pilot has been started...
See the instructions included with the remote for details on operation.
O |
|
|
N |
|
|
O |
|
|
F | F |
|
|
| |
Use this switch to |
| See the instructions |
| ||
| included with the | |
turn the main burner |
| |
| remote for changing | |
on and off manually. |
| |
| the battery. | |
|
|
For systems with thermostats, use this switch to control the temperature (right is hotter, left cooler). Some systems require the on/off switch to be on.
!Do not place any combustible items on top of or directly in front of the heater, even temporarily. The optional thermostat may start the heater causing a combustible item to ignite.
?If the heater turns on and off frequently while using the thermostat, you may want to adjust the flame height down until it produces just enough heat needed.
Adjusting the Flame Height
+Your heater has an adjustable flame to tailor the look and heat output to your specific needs. It is adjusted by turning the middle dial on the gas control valve.
Flame Height
Index Mark
VENT
Adjustment Knob
ON | VENT | ||
| OFF | HI | |
T | LO | ||
P | |||
O |
| ||
| L I |
| |
HI 
LO
PILOT ADJ
Turn clockwise to adjust the flame higher,
